281
edits
Changes
Jump to navigation
Jump to search
Line 70:
Line 70: − Insert Text+ Line 78:
Line 78: − ==Bending Steps==+ Line 103:
Line 103: + + + + +
→Troubleshooting
====Operation====
====Operation====
The bending brake is designed for forming straight bends in sheet metal by clamping the workpiece between a stationary bed and a pivoting bending leaf. To operate, position the sheet metal against the bed, align the bend line with the edge of the clamping bar, and secure it using the clamping handle. Apply steady, even force to the bending handle to lift the bending leaf until the desired bend angle is reached. For consistent results, ensure the material is properly seated, the clamping pressure is adequate to prevent slippage, and the bending motion is smooth.
====Demonstration====
====Demonstration====
====General Procedure====
====General Procedure====
*Bending Steps
#Ensure that your sheet metal is thinner or equivalent to 16-gauge sheet metal, and ensure that it is less than 48" in width.
#Ensure that your sheet metal is thinner or equivalent to 16-gauge sheet metal, and ensure that it is less than 48" in width.
#If making a bend for a box or a pan, adjust the fingers so that the equivalent width of the fingers is just shorter than your sheet metal.
#If making a bend for a box or a pan, adjust the fingers so that the equivalent width of the fingers is just shorter than your sheet metal.
==Troubleshooting==
==Troubleshooting==
*Uneven bend along length - Check that the workpiece is seated evenly and the clamping bar is parallel to the bed. Adjust clamping pressure if needed.
*Material slipping during bend - Increase clamping pressure and ensure the clamping surfaces are clean and free of oil or debris.
*Bend angle inconsistent - Verify that the bending leaf pivots smoothly without binding; lubricate pivot points as required.
*Difficulty moving bending handle - Inspect for mechanical obstructions, dry pivot joints, or exceeding the brake’s rated capacity.
*Material cracking at bend - Use material within thickness limits and consider increasing bend radius for brittle metals.
==Maintenance==
==Maintenance==