79
edits
Changes
Jump to navigation
Jump to search
Line 124:
Line 124: + + + + + + + + Line 145:
Line 153: − +
no edit summary
# After the cut is finished turn off the machine with the secondary power button but make sure to leave the main power switch on to prevent damage and wait 20 minutes before interacting with the graphic.
# After the cut is finished turn off the machine with the secondary power button but make sure to leave the main power switch on to prevent damage and wait 20 minutes before interacting with the graphic.
==Additional Functions==
While editing the image you will see 11 different tabs you can go under. Each of these has different ways to edit the image. Starting out, we are on the 'layout' tab. The next tab that we want to mess with is the 'color adjustment'. If your prints have colors that you don't want or a tint of a certain color, you can adjust the color to properly print your image.
[[File:Color.png|none|thumb|866x866px]]
The 'cut controls' tab can control the amount of passes, speed and force that the printer will perform. You most likely won't have to change anything unless you are using a different material to cut.
[[File:Cut.png|none|thumb|866x866px]]
The 'clip and tile' tab allows you to cut the image into different 'tiles' and have you image be split into multiple prints.
[[File:Clip.png|none|thumb|866x866px]]
These three tabs are the ones that you might need to use, if any.
Preparing for Transfers:
Preparing for Transfers:
==Troubleshooting==
==Troubleshooting==
*If for whatever reason the machine is being difficult, you can look in the upper left corner and the machine will most likely tell you what's wrong.
*If for whatever reason the machine is being difficult, you can look in the upper left corner and the machine will most likely tell you what's wrong. Where it typically says 'Printer Ready' it might say what the issue with the printer is.
* [[File:Vinyl1.png|none|thumb|866x866px]]
* [[File:Vinyl1.png|none|thumb|866x866px]]
* The most common issue is the printer beeping when trying to load a piece of material. To fix this, make sure the pinch roller is positioned above a grit roller by finding a new piece of vinyl or rotating/cutting down the current piece.
* The most common issue is the printer beeping when trying to load a piece of material. To fix this, make sure the pinch roller is positioned above a grit roller by finding a new piece of vinyl or rotating/cutting down the current piece.