Changes

## First, you need to get the image from inkscape into Trotec Ruby. This can be done by simply downloading the file and dropping it into Trotec Ruby.  

## First, you need to get the image from inkscape into Trotec Ruby. This can be done by simply downloading the file and dropping it into Trotec Ruby.  

## Second, you will click onto the design tab. All you need to do is verify that everything is the correct color that you need and everything looks fine. Once completed. Click on the blue "Create Job" button. This will allow you to move on.  

## Second, you will click onto the design tab. All you need to do is verify that everything is the correct color that you need and everything looks fine. Once completed. Click on the blue "Create Job" button. This will allow you to move on.  

[[File:R1.png|thumb|600x600px|none]]

[[File:Ex1.png|thumb|600x600px|none]]

## Third, you will need to prepare your cut/engrave. To do this you will need to align the laser with where you want to cut by dragging the grey square box. Then you need to select the material that you will be using to cut/engrave. DO NOT CHANGE ANY SETTINGS WITHOUT APPROVAL FROM SUPERVISOR.  

## Third, you will need to prepare your cut/engrave. To do this you will need to align the laser with where you want to cut by dragging the grey square box. Then you need to select the material that you will be using to cut/engrave. DO NOT CHANGE ANY SETTINGS WITHOUT APPROVAL FROM SUPERVISOR.  

[[File:R2.png|thumb|600x600px|none]]

[[File:Ex3.png|thumb|600x600px|none]]

## Finally, to produce the image press the "Push to Laser" button, this will open the next tab

## Finally, to produce the image press the "Push to Laser" button, this will open the next tab

[[File:Ex4.png|thumb|600x600px|none]]

[[File:Ex4.png|thumb|600x600px|none]]