Changes

# Make sure the drill press is turned off whenever you make adjustments to your workpiece.  

# Make sure the drill press is turned off whenever you make adjustments to your workpiece.  

# Mark your workpiece where the hole should be drilled, then use a hole starter to punch a hole for the drill bit if necessary.  

# Mark your workpiece where the hole should be drilled, then use a hole starter to punch a hole for the drill bit if necessary.  

# Put the appropriate drill bit into the chuck and use the chuck key on the drill press to tighten it. Make sure you tighten all three sides of the chuck. Chuck key on left, Chuck on right.[[File:...chuck.png|none|thumb]]

# Put the appropriate drill bit into the chuck and use the chuck key on the drill press to tighten it. Make sure you tighten all three sides of the chuck. Chuck key on left, Chuck on right.

# Adjust the position of the table for your workpiece.  

# Adjust the position of the table for your workpiece.  

## The table height and rotational position can be adjusted using the handle on the column:  

## The table height and rotational position can be adjusted using the handle on the column: