Changes

The Form 3 employs [[Prototype Lab#SLA Printing Anchor|SLA Printing]] (Stereolithography Apparatus). Due to friction caused by de-laminating every layer, every part should be canted in its orientation. This means the part should be angled in the PreForm software to reduce the cross sectional area needing to be shifted to de-laminate each layer. This ensures the wiper blade in the resin tank doesn't remove the print from the build plate. When reviewing the supports in PreForm, check to make sure all supports are created in areas from which they can be easily removed, or that supports created in inaccessible areas won't interfere with the print's intended function. Also check to make sure no supports are created on hard edges, as any placed supports will break up the edge, and removing them properly takes longer than necessary and can potentially damage the print.

The Form 3 employs [[Prototype Lab#SLA Printing Anchor|SLA Printing]] (Stereolithography Apparatus). Due to friction caused by de-laminating every layer, every part should be canted in its orientation. This means the part should be angled in the PreForm software to reduce the cross sectional area needing to be shifted to de-laminate each layer. This ensures the wiper blade in the resin tank doesn't remove the print from the build plate. When reviewing the supports in PreForm, check to make sure all supports are created in areas from which they can be easily removed, or that supports created in inaccessible areas won't interfere with the print's intended function. Also check to make sure no supports are created on hard edges, as any placed supports will break up the edge, and removing them properly takes longer than necessary and can potentially damage the print.

{{#evu:https://www.youtube.com/watch?v=8tn5zA5bNSE}}

{{#evu:https://www.youtube.com/watch?v=xf9oBcTzMFo}}

 

 

{{#evu:https://www.youtube.com/watch?v=dLIRAkXa6t8}}

==Documentation==

==Documentation==