Changes

* The job runs but machine does not cut. Most likely the dry run process selected. Toggle dry run off.  

* The job runs but machine does not cut. Most likely the dry run process selected. Toggle dry run off.  

*  The machine does not cut, many sparks visible. The process table is not set correctly or the cutting head or optics are dirty. Ensure correct focal offset, cut speed, cut height, and gas pressure in process table. Check that the nozzle tip is clean, wipe off slag with Scotchbrite.

*  The machine does not cut, many sparks visible. The process table is not set correctly or the cutting head or optics are dirty. Ensure correct focal offset, cut speed, cut height, and gas pressure in process table. Check that the nozzle tip is clean, wipe off slag with Scotchbrite.

*  Machine loses cut so that there crooked lines and gaps in the part. Again this is because the process table parameters14896  ''[Is this a true statement?]''

*  If the machine doesn't cut all the way through a part, a possible reason is that the wrong profile was selected in FabLight.

*  Incorrect or the cutting head/optics are dirty. Verify cut process parameters including cut speed, cut height, and gas pressure. Check nozzle tip is clean, wipe off slag with Scotchbrite.

*  Incorrect or the cutting head/optics are dirty. Verify cut process parameters including cut speed, cut height, and gas pressure. Check nozzle tip is clean, wipe off slag with Scotchbrite.

*  Cut does not go all the way through material. Select correct process. Reduce cut speed. Increase assist gas pressure up to 145 PSI. Verify process table is correct. Verify beam centering and focus test. Inspect nozzle tip.

*  Cut does not go all the way through material. Select correct process. Reduce cut speed. Increase assist gas pressure up to 145 PSI. Verify process table is correct. Verify beam centering and focus test. Inspect nozzle tip.

*  If your machine has a rotary you may encounter two homing errors. If the touchscreen says, “Idler (the chuck that holds the right side of the tube) not homed. Move idler to home”, open the door and move the idler all the way to the right. There is a sensor that detects when the idler is in its home position. Once the idler is in the home position, close the message and repress HOME THE MACHINE. If you encounter an error message saying that the rotary is locked; simply pull out the red pin, close the message, and repress HOME THE MACHINE.

*  If your machine has a rotary you may encounter two homing errors. If the touchscreen says, “Idler (the chuck that holds the right side of the tube) not homed. Move idler to home”, open the door and move the idler all the way to the right. There is a sensor that detects when the idler is in its home position. Once the idler is in the home position, close the message and repress HOME THE MACHINE. If you encounter an error message saying that the rotary is locked; simply pull out the red pin, close the message, and repress HOME THE MACHINE.

==Maintenance==

==Maintenance==

====General maintenance====

====General maintenance====