Changes

##Every part that needs support should have support - PreForm will highlight unsupported areas in red, place supports until the red areas go away. '''Check the part thoroughly because PreForm will not let you print with unsupported areas.'''

##Every part that needs support should have support - PreForm will highlight unsupported areas in red, place supports until the red areas go away. '''Check the part thoroughly because PreForm will not let you print with unsupported areas.'''

##Supports can be added, edited, and removed in the PreForm Supports tab.

##Supports can be added, edited, and removed in the PreForm Supports tab.

###Support density should be between .5 and .7.

###Support density should be between .5 and .7. This setting determines how many supports are placed per unit area of your print's surface.  

####This setting determines how many supports are placed per unit area of your print's surface.  

####Higher density → more supports, stronger holding power, better for tall, heavy, or delicate parts, but harder post-processing.

#####Higher density → more supports, stronger holding power, better for tall, heavy, or delicate parts, but harder post-processing.

####Lower density → fewer supports, easier cleanup, less resin use, but higher risk of part shifting or warping.

#####Lower density → fewer supports, easier cleanup, less resin use, but higher risk of part shifting or warping.

###Support point size should be between .6mm and .8mm.

###Support point size should be between .6mm and .8mm.

###These values can be edited if necessary to ensure printability, just use common sense when adjusting values.

###These values can be edited if necessary to ensure printability, just use common sense when adjusting values.